Echogear EGAV-CMOW2 Owner's Manual

#YourGearUpgraded
WARNING:
Not to be use to extend hard-wired (permanent) electrical wiring. Two power cord maximum capacity. Do not loop cord.
IMPORTANT:
Wall surface must be clean. Do not use on textured surfaces.
What's in the Box
a Cover
Strip
qty.3
Connectors
b
variety of shapes
outside
qty.7
elbow
T-fitting
1
. Measure Location(s)
TIP:
BEFORE adhering to the wall,
verify the spacing needed between strips
and connector(s) b for proper fit.
4
. Peel Liner from Tape
Confuzzled?
1-855-428-2490
helpmehelpyou@ECHOGEAR.com
Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim
that the information contained herein covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this product.
The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or implied, regarding the
information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
©2018 Milestone AV Technologies. All rights reserved. ECHOGEAR is a Milestone brand. ECHOGEAR and the ECHOGEAR logo are trademarks of Milestone. Made in USA.
Milestone Global Headquarters • 6436 City West Parkway • Eden Prairie, MN 55344 USA
ON-WALL CABLE
MANAGEMENT KIT
flat
elbows
inside
couplings
elbow
2
. Cut to Length(s)
a
5
. Press Firmly in Place
a
Clean the wall
surface
Call the ECHOGEAR Pros:
Grab your Tools
Pencil Level
a
a
Share a picture of your completed project with #YourGearUpgraded.
Who knows, it might not be as bad as you thought"
EGAV-CMOW2
Model
OWNERS GUIDE
Tape
Hacksaw
Measure
3
. Secure Cables
a
6
. Attach Connectors
a
b
a
"Wanna show off your hard work?
Paint Brush
Surface is
paintable/stainable
to match your wall.