Nature's Truth NT60024 Manual

How to Use:
Simply add a few drops of your favorite essential oils with water to the diffuser.
Home
Plug in any USB port around your home to fill a room with your favorite scents.
Office
Use the USB port on your computer for aromatherapy while you work.
Traveling
Traveling with your laptop? Taking a road trip? Plug into the USB port on your laptop!
1. Before using for the first time, remove wick from bag and soak in distilled water for
about 1 minute before inserting into circle-shaped holder under the cap. This is
necessary for proper diffusing. Use the USB port or USB cord extender to connect to a
computer, charging station or an adapter with a DC power voltage of 5V. Make sure
diffuser is unplugged when filling with water and oils.
2. Open cap and fill with water. Do not exceed max fill line located 1/4" below top of water
tank. Do not get rubber seal and metal element wet. Add up to 7 drops of essential oil(s)
to the water. Please use essential oils with water and not synthetic fragrance oils. Never
run diffuser with oil only. Dilute oils in water.
3. If seal on cap gets wet, the diffuser top will not stay tightly closed and the diffuser
may not function properly. If this happens, please follow these necessary steps.
o Remove the seal and dry seal thoroughly.
o Reinstall seal in original position and follow steps 4 and 5.
o If need be, you can run the diffuser without the seal but be careful not to tip over
diffuser because liquid contents will spill out.
4. Plug into USB power source. Once plugged in, choose diffusing options by pressing the
green power button on the base of the diffuser. When plugged in, 1 click begins
continuous misting, 2 clicks provides a spray of mist every 10 seconds, and 3 clicks shuts
diffuser off.
5. After each use empty any remaining liquid and wipe the inside clean. Remove wick and
use a cotton swab to clean metal element. Do not leave stagnant water inside the diffuser.