BUSHWACKER BodyGear 30909 Manual

Step 1:
Prior to Installation:
A) Bushwacker only approves installing the flares according to these
written instructions with the hardware provided. WARNING: Failure
to install according to these instructions will invalidate the warranty.
This includes, but is not limited to using alternative installation
methods, hardware, or materials. DO NOT USE: Loctite,
SuperGlue, or similar products on the hardware or the flares.
Fit:
B) Verify the fit of the flares to vehicle. (Some filing, sanding, or
cutting may be necessary to ensure proper fit).
Painting: (
C) Optional) if paint is desired it must be done prior to
installing flares on the vehicle clean outer surface with a good
grade degreaser. DO NOT USE LACQUER THINNER OR ENAMEL
REDUCER AS A DEGREASER. Wipe outer surface thoroughly with
a tack rag prior to paint.
Paint flares using a high quality enamel, or polyurethane automotive
paint. (Application of a primer coat is optional)
If painting edge trim (not recommended), use a flex additive.
:
Performance
D) Using larger Tires may increase the area required to
turn the vehicle. Some Tire/Rim combinations may require lowering
bump stops and or installing steering stops to prevent tire from
contacting flare.
Exhaust System:
E)
minimum 4" clearance between flares and exhaust pipes.
(Exhaust gases should not vent directly onto flares)
Metal Protection:
F) All exposed fasteners and bare metal should be
treated with red oxide primer BEFORE installing flares. Spray inner
fender wells with undercoating AFTER flare attachments have been
completed.
FLARE INSTALLATION PROCEDURES
Step 2: Edge Trim Installation
(See Illustration #1)
A) Peel two to three inches of red vinyl backing away
from edge trim tape. Applying the adhesive side of the
edge trim to the inner side of the flare, affix the edge
trim to the top edge of the flare (the portion that comes
in contact with the vehicle). See Illustration #1
B) Press edge trim into place along the top edge of the
flare in one-foot increments, pulling red vinyl backing
free as you continue to work your way around the top
edge of the flare.
6710 N. CATLIN AVE.  PORTLAND, OR 97203  503-283-4335  1-800-234-8920 (USA AND CANADA)  FAX 503-283-3007
Modifications may be necessary to maintain a
Toyota Tundra
B-Cab, D-Cab, CrewMax
Set Part # 30909
Rev- 2 01/15/10
TOOLS FOR EASY INSTALLATION

Socket Wrench

10mm Socket

#2 Phillips Screwdriver

Flat Head Screwdriver

Grease Pencil
Illustration #1