Oggi 7156 Assembly Instructions

1. Using a Phillips head
screwdriver attach the
center pole to the base
plates with the screw
and washer provided.
DISPENSING
LIQUIDS
Place glass under
the dispensing
unit. Push back
dispenser lever
arm to dispense
beverage.
CAUTION: NOT RECOMMENDED FOR BOTTLES WITH
IRREGULAR SPOUTS OR OVER 1-LITER CAPACITY.
OGGI CORPORATION, ANAHEIM, CA 92801
6 BOTTLE REVOLVING LIQUOR DISPENSER
ASSEMBLY INSTRUCTIONS
2. Using a Phillips head
screwdriver, tighten
locking screws on all
four sides. Do not over
tighten.
MANUFACTURED IN CHINA
3. Insert the rubber
stopper securely into
the neck of the
bottle. Carefully invert
bottle to
ensure no leakage.
CLEANING
DISPENSING UNIT
It is recommended
that you thoroughly
clean the unit when
changing bottles
as residue can
accumulate and
slow the flow of
liquid.
1. Twist locking ring
clockwise to open.
When replacing make
sure ring is properly
threaded to ensure a
liquid tight seal. Do not
over tighten.
Note: Use only warm
water to clean. Do not
place in dishwasher.
MODEL NUMBER -- 7156 ©2021, OGGI CORPORATION, INC.
4. Invert the bottle. Extend
spring loaded arm. Gently
push back the locking tab
and insert the bottle securely
on to the dispensing unit.
LOCKING
RING