Midwest Wire Mesh 13 Assembly Instructions

IMPORTANT INFORMATION!
1. If you discover any parts are missing, immediately call our toll-free service helpline at 1-800-428-8560.
2. Please save sales receipt as proof of purchase for warranty purposes.
Parts Identification
(A) 2 - Main Barrier Sections
(B) 2 - Small Extension Panels
(C) 2 - Large Extension Panels
(D) 2 - Rubber Tube Molding (installed at factory)
(E) 2 - Threaded Rods (inserted in tube at factory)
(F) 2 - Large Wing Nuts
(G) 2 - Large Lock Washers
(H) 12 - Plastic Clamp Plates
(I) 6 - Bolts & Small Wing Nuts
(J) 2 - Large Vinyl Tips
(K) 2 - Small Vinyl End Caps
(L) 2 - Short Rubber Tube Sound Dampeners
Assembly Instructions
Measure the width of the interior of your vehicle to determine how wide the Main
Barrier Section should be.
Remove the Threaded Rods (E) from the tubes on
the Main Barrier Sections and set them aside.
Identify the left and right main panels by placing
the panels on the ground with the tubes down.
Attach the Short Rubber Tube Sound Dampeners
(L) to the Left panel, were shown, to eliminate any
possible vibration rattles.
Lay the Left Main Panel on top of the Right Main Panel and adjust them to best fit your measurement
from Step 1. MidWest recommends that the panels be over lapped by at least 2 "squares," although
the barrier will still be stable with one overlapping square.
Locate 4 Plastic Clamp Plates, 2 small bolts and 2 small
wing nuts. Secure these panels together with the Clamp
Plates (H) as shown. Clamp plates should face
inward (as shown,) and for assembly
convenience, the bolt and wing nut toward
the back of the vehicle. Place the clamps
so they securely grab 2 wires on each
panel.
Assembly Instructions for Model 13
A
J
H
K
L L e e f f t t
MIDWEST Homes For Pets
P.O. Box 1031
Muncie, Indiana 47308
800-428-8560
www.midwesthomes4pets.com
Note: Illustrations not shown to scale
B C
L
Note: Illustrations not shown to scale
R R i i g g h h t t
E