- existing shower INSTALLATION Pre-drill 1/8" pilot holes to 1/4" Mark out two, 2" wide notches depth between the two marks onto the grout line. Remove grout with grout removal tool. Be careful not to damage membrane. Clean notches thoroughly.
Page 4
After cleaning thoroughly, apply a Insert install legs firmly into bead of silicon into each notch. notches, right leg first. Apply silicon around each Wipe away excess silicon Clean installation leg. silicon residue with denatured alcohol...
Page 5
- new remodel INSTALLATION After completing tile installation, Grout shower wall as usual, place 2" long spacers into install ensuring the 2" spacers don't tab locations. move. Carefully remove spacers after After removing spacers, clean out the grout is firm (or completely any remaining grit and apply set).
Page 6
Insert install legs firmly into Apply a tiny bead of silicon notches to at least 1/4" depth around both install legs. (right leg first). Wipe away excess silicon & clean residue with denatured alcohol.
CARE & CLEANING General Care All the Redblock products are constructed out of sheet stainless steel, so you must treat them with the same care as any other stainless steel appliance in your home (like your fridge, dishwasher, etc). As you are probably already aware, stainless steel will scratch if you drag anything abrasive across its surface.
Page 8
I N D U S T R I E S L L P 2950 Newmarket St. #101-191 | Bellingham WA 98226 | T: 1-877-347-8148 sales@redblockindustries.com | www.redblockindustries.com...
Need help?
Do you have a question about the rb3 and is the answer not in the manual?
Questions and answers