Accuform DIGI-DAY 2 Setup Instructions

How to Set-Up Your
Electronic Scoreboard
Follow these step-by-step instructions to set-up your digital display
Digital Display
Power Loss Indicator
Segment 1 Segment 2
Power Loss Indicator
In the event of a power loss, the display will go dark, yet will hold in
memory the Number of Days, Date and Time. When power is restored,
there will be an LED indicator on the upper left and the complete display
will be red. The display will resume normal operations – though, time
shifted back by the amount of time power was off. To verify (and reset)
the time of day, remove power loss indicator, and return the display back
to green, follow procedures in "Set the Time of Day".
Step 1 Verify Count-Up Function
Your Digi-Day display has the ability to count-up OR count-down.
®
• Press remote gray "Up/Down" button once
mode. In display segment 1, the horizontal bar is to be at the top for
"Count-Up" mode, or at the bottom for "Count-Down" mode.
• After verifying, on the remote, press the black Enter button.
Display shown in Count-Up mode
8
www.accuform.com
Counter Indicator On Hold
Segment 3 Segment 4
AM (GREEN) PM (RED) Indicator
to verify the correct
Display shown in Count-Down mode
)
Counter Indicator On Hold
To freeze or pause the number of count days, press the remote "Hold"
red button. There will be an LED indicator on the lower right, and the
count will hold or freeze. To resume function, press remote "Hold"
button. LED indicator will turn off.
Step 2 Set the Number of Count Days
• Press remote green "Count Days" button.
will flash.
• Press remote's green numbered buttons
of days. As each number is entered, the next segment will flash.
• After entering numbers,
Example: 365 days – Enter 0-3-6-5 for number of count days.
black Enter button.
Note: the leading zero(s) will not appear during operation.
DD2FORM v1.0 | © 2013 Accuform Signs. All rights reserved.
800.237.1001
Set-Up Instructions
Remote Control
Replacement Part No.
SCG444*
All Digital Display functions
require the use of the handheld
Remote Control.
*The Remote Control is encoded to the
Digital Display. Please refer to the last
letter code listed on the Digital Display
when ordering replacement or additional
remote control.
First segment number
to enter desired number
press the black Enter button.
7
800.394.4001
Press the