kdgarden B07MMLHNYZ Installation Instructions

INS TALLATION INS TR UCTION
Vinyl Easy Sign Post
A
Tool Required
B
C
D
Hammer
E
F
Screwdriver
G
Part List
A. Post Cap (1)
B. Rail Key (1)
C. Rider Clip Kit (2)
D. Rail End Cap (2)
E. Sign Clip Kit (2)
F. Post (1)
G. Anchor (1)
Installation Steps
Step 1
Use a hammer to drive the
Steel Anchor into
ground
Make sure that anchor is
straight while hammering.
The anchor should be driven
downwards until the bottom
plate is flush with the
ground. The bottom plate
should be facing forward in
the desired direction of real
estate post arm.
Step 2
Slide the vinyl real estate post
the anchor until it touches
into
the ground. The hole on the
post should be at the top and
facing in the desired direction of
the sign arm.
Step 2
Step 3
Use a screwdriver and attached
screws to fix the rider clips on
top of post arm.
36"
.
Step 1
Step 3
Step 4
Slide the vinyl rail into the
post. Make sure that the
rider clips are facing up.
Slide the arm through the
holes until the slots are
ali on the inside of the
gned
post.
Step 5
Slide the key into the slots
of the real estate post arm
until it locks in place. This
will secure the arm.
Step 5
Step 6
Slide the post cap onto the
top of the real estate post.
And slide the rail cap onto
both side of the arm.
a
Step 7
Insert the sign clip screw through the arm,
and then fix the screw.
Note: You need to choose the right hole on
the arm to fit the size of your signs
Customer Service Mail:
kdgarden.customer.service@gmail.com
Step 4
Step 6
b c
Step 7