Architectural Mailboxes 3582B-0 Installation Instructions

house number installation instructions
1
Manually screw the blunt ends of the included screws into
the back of the house number as shown in the figure.
4
Manually push the number into the holes or anchors. If
necessary, gently pound the number into place being careful not
to damage the number surface.
Optional: Leave the screws partially out of the holes or anchors
for a floating number effect.
(310) 374-5700
2
3
For wood walls, drill a 3/16" pilot hole at
each marked location.
For stone, concrete or stucco walls, drill a
5/16" hole to a depth of 1-1/2" at each
marked location and push the included
plastic anchors completely into the holes.
Made in India © 2018, Architectural Mailboxes
www.architecturalmailboxes.com
Mark the wall at the desired
location using the number with
attached screws as a guide.
R