fine fixtures BT106 Installation Instructions

DROP IN BATHTUB
INSTALLATION INSTRUCTIONS
Important Information
The bath must only be supported by the feet or base. Do not support the
bath by the rim.
Before installing a rim-mount bath faucet, refer to the online product
specification sheet. Ensure clearance under the rim before drilling faucet
holes in the rim.
Provide adequate floor support. Refer to the specification sheet for specific
floor-loading requirements.
Make sure the subfloor is level. Provide drain access from below. Provide
access to all plumbing connections. Observe all local building and plumbing
codes.
1
. Construct the framing. Refer to the
speci cation sheet.
4
.
Install the drain to the bath.
8
. Make the nal drain
connections. Position a
protective liner
in the bath basin.
2
. Optional Add-On Apron:
Refer to the apron
instructions and
provide necessary
support.
5.
For adhesive installation, apply a
generous amount of construction
adhesive to the bath feet or base.
9
. Install water-resistant wallboard
Water-Resistant Wallboard
11
. Apply 100% silicone sealant around
the bath along the nished walls and deck.
Silicone Sealant
Conventional woodworking tools
and materials for better installation
*Drop cloth
*Construction Adhesive
3
. Install the rough plumbing.
7
. With help, lift the bath into position.
Verify level. Ensure the feet or base
are fully supported.
10
. Install the nished wall and deck
material to within 1/16" (2 mm) of
the bath rim.
Finished Material
F O R A L I F E O F S T Y L E
206 wembly Road.
New Windsor, NY 12553
Phone: 718.602.6060
Fax: 718.963.2082
info@ ne xtures.com
www. ne xtures.com
100% Silicone
Sealant
TM