Nekteck SPOT-WARM-2P Instruction Manual

Solar Spot Light INSTRUCTION MANUAL
READ THE INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY AND
INSTALLATION.
CHARGING AND OPERATION:
1. Charge the solar product by placing it under direct sunshine for at least
8 hours.
at "LOW" level.
IMPORTANT:
1. Install the solar product in an area where it can get direct sunlight.
2.
light stays at "LOW" level .
3. Select an outdoor loca
street lights. Other lights may cause the product to not turn on automa
night.
4. Dura ht depends on solar product's level of sunshine exposure,
geographical loca
MAINTENANCE, TROUBLE SHOOTING AND BATTERY REPLACEMENT
1. Keep the solar panel clean.If the light does not light up when it's brand-new,
leave the solar panel under direct sunlight to charge the light for a while and test
it again. (test it on the dark place)
2. If solar product does not light up a er it has been used for around 1.5 years,
replace the rechargeable ba eries as they may be weak or worn out.
(Ba ery 1 pc 18650# 3.7v （Cusp design)
as recommended must be used).
3. Exer
the old ba ery with a new one. Ba ery must be recycled or disposed of properly,
don't
Warranty
We provide all our customer 18 months warranty from the date of its original
purchase. if the device fails due to manufacture defects, please contact us by
email at support@nekteck.com to launch a warranty claim, we will instruct you
on how to return the product or repair/replacement.
18650 lithium battery
away from other light source at night, such as
s, weather c
replacing ba eries. Open the ba ery cover to replace
level, 9-12 hours
aylight.
a er
at
valent type