Summary of Contents for Anbull 75132-1
- Page 2 Maintenance................. Troubleshooting..............
- Page 3 Components such as the filtration system, pumps and heater must be positioned so as to prevent their being used as means of access to the pool by young children. Page of 13 Page of 13...
- Page 4 This sand filter is for use with storable pools only.Do not use with permanently installed pools storable pool is constructed so that it is capable of being readily disassembled for storage and reassembled to its original integrity permanently installed pool is constructed in or on the ground or in a building such that it cannot be readily disassembled for storage.
- Page 5 Page of 13 Page of 13...
- Page 6 Page of 13...
- Page 8 Blockage of suction fittings can cause serious or fatal injury due to drowning. To reduce the risk of injury, do not permit children to use Never work on the pump while it is running or power is still connected. High voltage can cause serious or fatal injury. A suitable ground fault interrupter (GFCI) should always be installed at the power supply source of this unit.
- Page 9 You must use only No. 20 standard silica sand having a uniformity coe!cient of 1.75 or less. No. 20 silica sand has a particle size of .018-.022 inches (.45 to .55 mm). Note: Sand not included. Position the valve so that the port locations are in the desired final position.
- Page 10 KEEP SAFETY LABELS IN GOOD CONDITION AND REPLACE IF MISSING OR DAMAGED. Page of 13...
- Page 11 DO NOT DRY RUN THE PUMP. 10. Check the system for water leaks. If a leak is found, shut the pump o! before correcting the leak. Page of 13 Page of 13...
- Page 12 If, at any time, the starting pressure after backwashing the filter indicates 4 to 6 PSI higher than normal starting pressure, it is time to perform a chemical cleaning procedure. Page of 13...
- Page 13 Always turn pump off before changing valve positions. Changing valve positions while the pump is running can damage the control valve, which may cause serious injury or property damage. 11. The filter has now started its filtering cycle. Verify the water is returning to the pool and take note of the filter pressure when the filter is clean.
- Page 14 Allowing water to freeze in the system will damage the system and cause potential water damage/flooding and potential property damage. The multiport valve should be left in the “WINTER” position during the shutdown season. Failure to do so can damage the system which can cause property damage from leaking water.
- Page 15 Page of 13 Page of 13...
Need help?
Do you have a question about the 75132-1 and is the answer not in the manual?
Questions and answers