oraimo OSV103 Troubleshooting

Display
0% （Flashing）
Low battery
E1 Motorized floor head clogging
E2 Host overcurrent
E3 Host wiring is abnormal
E4 Overheats during use
E5 Brush head short circuit
E6 Air duct blocked
1E0 Overvoltage while charging
1E1 Overcurrent while charging
1E2 Overheat while charging
1E3 Always not full-charging
Troubleshooting
Problem
Fully charge the machine.
Check the floor head and solve the blockage problem.
1. If water get in the machine, place the machine in a dry and ventilated place,
wait for the machine to dry before use.
2. If the main motor blocked, check the main motor.
3. For other reasons, please contact us.
Please contact us.
1.Recommended to use it in a room temperature environment.
2.Place the machine in a room temperature environment, and turn on after 4
hours.
3. If error again, please contact us.
1. If water get in the machine, place the machine in a dry and ventilated place,
wait for the machine to dry before use.
2.For other reasons, please contact us.
1.Clean the air duct, including brush head, aluminum tube, dust container, etc.
2. If error again, please contact us.
1.Check if you are using a non-original adapter.
2. If error again, please contact us.
1.Check if you are using a non-original adapter.
2. If error again, please contact us.
1.Recommended to charge it in a room temperature environment.
2.Place the machine in a room temperature environment, and charge it after 4
hours.
3. If error again, please contact us.
1.Check if you are using a non-original adapter.
2. If error again, please contact us.
Solution