Page 3
ASSEMBLY 1.Before mounting the appliance, make sure it is unplugged; 2.Assemble the front base(3) and rear base(2) into one; 3.Install the base to the corresponding position of the fan body(1), and the hole corresponds to the pillar; 4.Put the power cord(4) through the center of the nut(5) and tighten the nut(5); 5.Clip the power cord into the middle slot of the rear base; ASSEMBLY CONPONENTS Fig 1 1. Body 2. Back base Fig 1 3. Front base 4. Power cord 5. Nut USINGTHE REMOTEICONTROL 20Ft 1.The sensor of the remote control must be pointed at the fan receiver to operate properly;...
Page 4
Use remote control(See Fig3) and button(See Fig4) control please see the following table Main control panel & Indicator Features Remote Control Lights switches POWER Standby mode. The fan is ready to use but has not started operating yet. ON/SPEED Press Once - Low Wind speed setting Press twice - Medium Wind speed setting...
Page 5
Fig.5 Fig.6 Fig.7 Tips:Do not overexert when replacing the fuse or damage may occur.If it’s hard to close the access cover,make sure the fuse is fully inserted.
Need help?
Do you have a question about the HIFANXTOWER32RC and is the answer not in the manual?
Questions and answers