FRIGGA M2 Manual

M�
Start the device
➀
Confirm whether the device has been turned on: Tap "Stop" and the screen
displays "����", which means the device is brand new, and hasn' t been
turned on before.
➁
Start the logger: long press "START" for � seconds until the blue LED blinks
and then release it within �� seconds.The logger enters into start delay mode
for �� min (blue LED blink every �� seconds).
➂
After start delay, the logger starts recording data.
➃
Parameter settings: After turning on the device, go to Frigga website
(https://www.friggatech.com/application) to download Frigga Data Center,
please refer to the software manual for the user guide. Connect the device to
a computer and set the device parameters through the Frigga Data Center
software.
Work Status Instruction
�.SLEEP MODE
www.friggatech.com
China.Norway.Netherlands.Spain.UK.Chile
�.START DELAY
➄
Re-start the device: Press and hold the "START" button for � seconds.
➅
Please note: When the device is connected with the computer, the device
pauses the recording of data and the screen displays "STOP". Please re-start
the device after setting the parameters.
Stop the device
➀
Stop the logger: long press "STOP" for � seconds until the red
LED blinks and then release it within �� seconds.
➁
Short press "START" button for � second, and refer to below work
status instruction of the logger.
Note: If disable manual stop function, stop device by connecting with PC.
�.RECORDING MODE �.GENERATING REPORT �.STOP MODE
contact@friggatech.com