Do you have a question about the AEO-SIS4D50-KIT and is the answer not in the manual?
Questions and answers
Summary of Contents for AEO AEO-SIS4D50-KIT
Page 1
USER’S MANUAL 1.OVERVIEW AEO Solar-powered irrigation system is an application of solar-powered water pumping system used in gardens for watering the plants, vegetables. The automatic solar garden irrigation system is designed for home gardening; reduce labor and time to maintain soil moisture for flowers and vegetables.
Page 2
Part Description Specs Quantity Schematic Dripper 0.5G/H Earth rod 4” Siphon breaker Tee reducer Ф5/16”–Ф5/32” Tee distributor Ф5/32” End cap Ф5/16”–Ф5/32”...
Page 3
Part Description Specs Quantity Schematic 5/16” Diameter Water intake hose 6.5 ft length 5/16” Diameter Main supply hose 22 ft length 5/32” Diameter Distribution hose 155 ft length Installation pieces 4 set 3. CAUTIONS [MUST READ] Any altering of the product itself or changing of the components voids warranty. Operate the pump in water only (never above 40℃), especially keep it away from flammable liquids.
4. CONSTRUCTION GUIDE 5. INSTALLATION STEP BY STEP Unpack all components carefully. [CONTROL UNIT] Find an appropriate location for the placement of the control unit. The location should be able to avoid the control unit getting soaked into water when raining. The control unit can be installed vertically (recommended) as shown in Figure 2 or lay it flat.
Page 5
[SOLAR PANEL KIT] Solar Panel needs to be fully exposed under the sun, do not leave it under the shade or any coverage. Install the solar panel with the ground spike. Facing Solar Cells towards the midday sun and tightening the gland nut as shown in Figure3 and Figure 4.
[WATER LEVEL DECTECTOR] Roll out the cable from water level detector and insert the plug to the socket on the control unit labeled “Water Level” as shown in Figure 6. Push the water level detector into the dedicated base on the top of the water filter as shown in Figure 7 and place the water filter and the attached detector on the bottom of the reservoir.
Turn on the control unit by the SYSTEM ON/OFF switch and the SYSTEM indicator on the panel will light as shown in Figure 10 and Figure 11. SYSTEM indicator could be in one of the below three colors, proceed only when it is green Green: The system is ready for operation.
Page 8
3) CLEAN DRIPPER PERIODACLALLY. If there is no water come out of a dripper, check and clean all parts of the dripper as shown in Figure 14. 4) If the working minutes per watering session fall short of the setting value, replace the battery that is exhausted with a new one (Referring to Figure 15).
Need help?
Do you have a question about the AEO-SIS4D50-KIT and is the answer not in the manual?
Questions and answers