Camco 51892 Instructions

Instructions for 51892 Aluminum Roll-Up Campsite Table with Carrying Bag
Camco's Aluminum Roll-Up Campsite Table with Carrying Bag is quick and easy to set up. Includes: (1) table top, (1)
frame, (3) support rods and (1) carry bag. When assembled, the roll-up table measures 28-inches tall x 43 ½-inches long
x 27-inches wide and collapses to a compact 7-inches x 45-inches x 5 ½-inches.
Assembly:
1. Remove the roll-up table pieces from the black carrying bag. The table top will be rolled up in a piece of Kraft paper
and be inside a bubble bag. The frame and support rods will also be in the bubble bag. Remove all pieces and
confirm that you have all five parts (shown above).
2. Unfold the frame legs until they are in direct contact with the side rails. This creates the base of the table.
Note: If the legs are unstable, they may not be folded in the correct position. To ensure the correct orientation,
make sure the attached rivets are facing upwards once opened. Do not fully extend the frame prior to installing
support rods.
3. Next, attach one support rod at a time by aligning the keyhole slots with the rivet heads. Once all three support rods
are installed, fully open the frame to allow the rivet heads to move inside the keyhole slot. Do this until each rivet
head is fully secured and locked in the outer most position (as shown).
4. Unfold the table top. Align and slide the black plastic brackets (located on the underside of the table top) onto the
ends of the support rods. Once the first side is in place, attach the opposite side in the same manner.
- Note: The table top slates have an elastic cord holding the parts together. This allows you to pull and stretch the
parts to assist in assembly.
5. Place the table on a flat surface for maximum support and stability.
Disassembly:
1. To disassemble, simply perform the assembly steps in reverse.
2. Place the roll-up table pieces back inside the carrying bag.
Approved