Related Manuals for DigiTech C1
Summary of Contents for DigiTech C1
- Page 1 A Harman International Company Control One Remote Foot Controller For use with the 2112 SGS, GSP-2101, Valve FX and Legend II Owner's Manual...
-
Page 2: Table Of Contents
Table Of Contents Safety Precautions.........................2 Warranty............................2 Quick Start............................3 Introduction ..........................3 Modification Decals ........................3 Section 1 - Startup Front Panel Controls and Functions ....................4 Program Switches........................4 Program / Bank Selector ......................4 Bypass Switch.........................4 Continuous Control Pedal.....................4 Rear Panel Connections ......................4 Control Output........................4 External Continuous Controller Input..................4 Section 2 - Basic Operation... -
Page 3: Safety Precautions
In no event shall DigiTech or its dealers be liable for special or consequential damages or from any delay in the per- formance of this warranty due to causes beyond their control. -
Page 4: Quick Start
After you've had time to familiarize yourself with the unit, try experimenting with unusual continuous con- troller Parameter links. You may get some interesting results. DigiTech is always looking for new ideas, so if you feel that you’ve created something unique, send us your ideas at the address on the back cover of this man- ual. -
Page 5: Section 1 - Startup
Section 1 - Startup Section 1 - Startup Front Panel Controls and Functions The front panel of the Control One consists of a 20 character vacuum-fluorescent display, ten programmable footswitches, a dedicated bypass footswitch, a Select switch, and the built-in continuous controller pedal. •... -
Page 6: Control Output
Section 2 - Basic Operation • Control Output - The Control Output is a 5-pin DIN connector (MIDI-type). All control information gen- erated by the Control One is sent out the Control Output to the 2112 SGS, GSP-2101, Valve FX or Legend II. -
Page 7: Foot Controller
Section 3 - Programming the Control One Section 3 - Programming the Control One All programming and setup for the Control One is performed from the front panel of the 2112 SGS, GSP-2101, Valve FX or Legend II. Most of the setup menus that deal with the Control One can be found in the Foot Controller section of the Utility setup menu. - Page 8 FAX (801) 566-7005 International Distribution: 3 Overlook Drive Unit 4 Amherst, New Hampshire 03031 U.S.A. FAX (603) 672-4246 DigiTech™is a registered trademark of DOD Electronics Corporation Copyright © 1997 Digitech Electronics Corporation Printed In U.S.A. 5/97 Manufactured in the U.S.A.