Establishing Bluetooth Link; Transferring Calls; Muting The Microphone; Ending Calls - Ativa AT-BT120 User Manual

!

Establishing Bluetooth Link

After successfully pairing the AT-BT120 and the mobile phone, you may need to establish a
Bluetooth link between them according to the operation manual of your mobile phone. To
establish the link, press S1 shortly. Use Nokia 6130i as an example, the mobile phone will show.
Do you accept AT-BT120 request for connection?" Select YES to establish the link. You are ready
to make and answer calls on the Headset. For other phones, please follow the operation manual
to establish the link.
!
Answering Incoming Calls
When an incoming call is present, the AT-BT120 headset will ring. Pressing S1 will answer the
call.
Attention: Some phones put the Bluetooth connection into Standby Mode if it has not been used
for some time. If a call comes in only the mobile phone rings and it will take a few seconds before
the call is transferred to the Headset as well (2-3 ringtones). You have to wait taking the call until
you hear the ringtone in the Headset. If you press S1 too early before the call is transferred to the
Headset, the Headset will try to establish a Bluetooth connection and cause conflicts in the mobile
phone.
!

Transferring Calls

(For Nokia 3650 or equivalent models)
When you are in session, calls can be transferred from the Bluetooth phone to the HS and
from the HS to the Bluetooth phone.
To transfer a call from the Bluetooth phone to the HS: press S1 once, the call will be
transferred to the HS.
To transfer a call from HS to the Bluetooth phone, please follow the operating instructions
of your phone .
!

Muting the microphone

To mute the microphone during an active call press both S2 and S3 buttons simultaneously
for about a second and the microphone will be muted. A periodic beep tone will be heard
while the mute function is active.
To end the mute function: When the microphone is muted, press on both S2 and S3 buttons
simultaneously. Mute function is ended and the periodic beep tone will stop.
!

Ending Calls

While a call is in session on the Headset pressing S1 will disconnect the call. After the call
is disconnected, the blue LED will flash normally again.
3
!
To make a new call using voice dial:
Make sure the voice dialing function is probably set up in the mobile phone and it is within
the range of the Headset. Press S1 on the AT-BT120 shortly. After the beep tones on the
Headset, use your recorded voice commands ( eg. by saying the name of the person). The
call will be connected in a few seconds.
!
Redialing last dialed number (Mobile phones with Handsfree profiles only )
To redial the last dialed number, press and hold S3 for 1 second, 4 tones will indicate an
attempt to redial.
!
Reject a call (Mobile phones with Handsfree profiles only )
To reject a call at the time the AT-BT120 rings, press and hold S1 until you hear 2 tones.
!

Adjusting Speaker Volume:

While a call is in ongoing, pressing and releasing S2 will increase the speaker volume and
pressing and releasing S3 will decrease the speaker volume on the Headset. There is a key
tone to indicate volume increase or decrease. However, a warning tone will be heard when
the volume level reaches its maximum or minimum.

! Right or left ear

If you want to change the orientation of the ear hook, please follow the following steps.
1) Detach the ear hook carefully from the headset body
2) Select the orientation you want (left or right), and attach the ear hook and lock it
4