Woods Pro 59406WD Manual

Woods Pro 59406WD
1. Turn off the light and carefully remove the bulb.
2. Install the pre-packaged cylinders over the photo eye.
The cylinder is used to reduce or restrict any amount of ambient
or peripheral light from entering into the photo eye.
3. Choose the desired manual ON/OFF; 2. 4, 6, 8. or Dusk to Dawn
setting.
4. With the bulb and the cylinder installed in the programmed
photo-controlled adapter, reinstall the entire unit into the light
socket, by way of holding the bulb.
5. Continue turning the bulb/adapter combo completely—DO NOT
Tighten the unit!
6. Identify the direction in which the photo eye/cylinder combo is
turned.
7. If it is not
coverage, back it out or begin unscrewing it until it is.
8. Turn the light switch on--observe the light coming on organically
and remaining on for approximately
to its natural
9. Once the light turns off, your product is ready to operate as
intended.
facing in the direction of your largest landscape
environment.
two minutes as it acclimates