Tab R6 Troubleshooting

Status
The machine beeps 3 times and
The white sensor block of the dirty water tank is not at
cannot be used
the lowest part
The plug is not properly connected and loose,
resulting in poor contact.
The machine does not
work after the switch
The internal line or power cord is broken.
is turned on
The machine set overheats and the
protective device operates.
Nozzle blockage
Water shortage in clean water tank
The product does not spray water
The internal water pipe is blocked or broken
The suction port of the product is blocked or large
waste is inhaled
Abnormal noise
Motor failure
Too much dirty water in the dirty water tank
Weak suction or no water
Hose is broken
absorption
Dirt blocking the suction
Abnormal or inoperative machine The ambient temperature is too high or too low
Slow heating of boiler
Hot water is not hot
The boiler is not heated
Possible causes
Adjust the white sensor block of the dirty water
tank is not at the lowest part.
Turn off the power and plug it again.
Call the repair telephone.
Refer to the instructions for protective device.
Remove the nozzle blockage with a fine needle
Add water to the clean water tank in time
Contact the merchant or after-sales
Clear blockages in time
Contact the merchant or after-sales
Clean the dirty water tank in time
Replace the hose with a new one
Clear blockages in time
Keep the machine at a suitable ambient
temperature (0℃-50℃)
Contact the merchant or after-sale
Contact the merchant or after-sales
Processing method