Dramm 15065 Instructions

Impulse Sprinkler Instructions
Water Adjustments
Two Silver Colored Clips – Used to direct the radius of the spray. By spreading them out you can choose
the rotational field of the sprinkler. Squeeze the two ends of each clip to move and position them. Use
the trip pin by pulling it to the down position. It will bump into the clips and reverse the rotation of the
head. If you would like to water 360 degrees flip the trip pin up. This will allow the head to rotate
completely.
Pin and shield – Used to create the desired reach and spray pattern of the water. If these are clear of
the water stream your water will project out in a full strong stream. If you want a more diffused or
gentle water pattern you will tighten the brass screw to have it interrupt the water pattern. Depending
on the desired pattern you would like you can have the screw tip just hit the spray or enter quite a way
through the spray. To Change the arc of the water you will use the shield. Lower it to deflect the water
to reach a closer area.
Utilizing these different options, you will be able to can create very precise water pattern. Please do not
hesitate to call if you need any help with adjusting your sprinkler.
Thank you for being a Dramm Customer.
Laura Henderson
800-258-0848