Old Dutch 106 Series Manual

SCREWS
(X27 plus 2 Extra)
UPPER STAND
UPRIGHTS (X3)
1. Unwrap all parts. Sort out the shelf components into 6 sets of
3 shelf sections each of equal size (from "A" to "F", largest to
smallest).
2. Locate the 3 lower stand uprights (these will have at feet on
one end) and shelf set "C". Using only the bottom row of holes
on each shelf set, attach shelf section "C" to the lower stand
uprights. Use 2 sets of screws and nuts for each joint and
hand-tighten. Take care to keep all screw and nut sets going
in the same direction.
3. Locate the 3 upper stand uprights (these will have scrolls on
one end). Attach to shelf section "C", using 2 sets of screws
and nuts for each joint. Take care to keep all screw and nut sets
going in the same direction. Tighten all screw/nut sets.
4. Attach shelf sections "A", "B", "D", "E" & "F" to the upper &
lower stand uprights, using one screw/nut set at each joint. Take
care to keep all screw and nut sets going in the same direction.
Hand-tighten only.
5. Square up the stand so that the feet sit at upon oor and all
shelves are straight. Tighten all screws and nuts.
It is important that your rack is properly assembled and mounted.
If the rack is incorrectly assembled, mounted or used it could become unstable
Old Dutch International | Email: customerservice@olddutchco.com | www.olddutchco.com
60" HT. 6 Shelf Cookware Stand
PARTS LIST
F
SHELF F (X3)
E
SHELF E (X3)
D
SHELF D (X3)
C
SHELF C (X3)
B
SHELF B (X3)
A
SHELF A (X3)
Assembly
or collapse, possibly causing damage or injury.
Series #106
NUT BOLTS
(X27 plus 2 Extra)
LOWER STAND
UPRIGHTS (X3)
Decor Copper Finish: The copper plating has been given a
clear, protective coating to prevent tarnishing. Clean with a soft,
damp cloth. You can also use a window cleaner. Dry thoroughly.
Never use abrasive cleaners.
Satin Nickel Finish: The nickel plating has been given a clear,
protective coating to prevent tarnishing. Clean with a soft,
damp cloth. You can also use a window cleaner. Dry thoroughly.
Never use abrasive cleaners.
Chrome Finish: Clean with a soft, damp cloth. You may also use
a window cleaner. Dry thoroughly. Never use abrasive cleaners.
Powder Coat Finish: Clean with a sponge, moistened with
dishwashing solution. Dry thoroughly. Never use abrasive
cleaners.
Warning:
Top Scroll Top Scroll
F F
Upper Stand Upper Stand
Upright Upright
F
E
E
E
D
D
D
C
C
C
B
B
B
Lower Stand Lower Stand
Upright Upright
A
A
A
Flat Feet
Care and Use