Megiu HC-24G2 Manual

Megiu Car Refrigerator Cooling Performance Self-inspection Guide
Dear Customer:
Hello! First of all, thank you very much for your trust in the Megiu car refrigerator; For a
newly received refrigerator or a refrigerator that has been used for some time, how to check the
cooling performance by yourself? We suggest the following:
Preparation:
1. Empty the empty refrigerator box and take out all the objects inside.
2. Open the refrigerator door and allow the inner liner to return to room temperature, then close
the door and set the temperature to -18°C.
Judgment method:
Check the refrigerator LED display, if the display shows the temperature (The display is the

actual temperature inside the refrigerator), it means that the refrigerator is energized normally;
The compressor will start three minutes after the power is turned on, and the refrigerator
cooling fan will work synchronously at this time, sucking air from the back holes and
discharging hot air from the sides and front. If you feel the hot air is very hot, do not worry,
this is a normal phenomenon.
There will be vibration when the compressor is running. It can be felt by putting your hand

on the refrigerator; If you do not feel the vibration, it means that the compressor is not
working.
Determine that the compressor is running. You can feel the walls of the refrigerator liner with

your hands (No water droplets on hands to avoid frostbite), and the refrigeration tube
wrapped around the wall of the inner liner, If the refrigeration performance is normal, is able
to touch the liner wall cool feeling.
Criteria: If,
Refrigerator compressor is working;
1
The walls of the liner also feel cool to the touch, allowing the refrigerator to continue to run;
2
At temperatures not exceeding 35 ℃, the refrigerator no-load operation to reduce from room
3
temperature to -18 degrees in 2 hours; It will shut down when the set temperature is reached;
Reach the above conditions that the refrigerator refrigeration performance is normal, and vice
versa is not normal, the machine may need to be aftermarket repair.