Danner Supreme-HYDROPONICS 49922 Manual

IMPORTANT: The DRAIN FITTING must always be larger than the FILL
FITTING to allow su cient draining of ood table to prevent over ow.
1
ASSEMBLE UPPER FITTINGS
FILL FITTING DRAIN FITTING
STRAINER ON FILL
The larger barbed
FITTING MUST BE tting is used for the
LOCKED BEFORE drain. The strainer
height of the DRAIN
ACTIVATING PUMP.
tting will determine
The strainer disperses
the water level in the
the water ow when
ood table during the
the pump is on and
ow cycle.
lters out debris
during the drain cycle.
Adjust height after
installation. See
DRAIN FITTING height
adjustment section.
LEAVE / "
1
2
Strainers
SMALLER
Barbed
Fitting
Rubber
Washers
1 / " Holes
1
4
FLOOD
TABLE
FLANGE SIDE UP
Lock
Nuts
5
ATTACH TUBING AND PUMP
Connect barbed Attach a short
tting to your pump section of exible
with exible tubing*. tubing* to the Drain
A control valve* can be Fitting to divert
used between pump water back into
and barbed tting if reservoir and reduce
your pump does not splashing.
include an integrated
ow control.
*Not Included
STRAINER ON FILL
FITTING MUST BE
6
LOCKED BEFORE
ACTIVATING PUMP.
*Not Included
DANNER Mfg. INC. • Islandia, New York 11749
APPROXIMATE DOCUMENT SIZE
2
DRILL HOLES IN FLOOD TABLE
To install Fill and Drain ttings you will need to drill two 1
holes into the Flood Table of your Ebb & Flow system. Carefully
select the locations of the holes to avoid interference with other
components of your set-up. Holes should be a minimum of 4"
apart. Use a 1 1 / " hole saw to provide perfect openings. They can
4
be located on any at area on the bottom of the Flood Table.

SEE "IMPORTANT NOTES BEFORE DRILLING".
EXAMPLE*
IMPORTANT NOTES BEFORE DRILLING:
To determine best hole locations do the following:
Temporarily set up your Flood Table using your preferred

support system to check for and avoid interference with
ttings after installation.
Lay out all growth trays and any components that will be

used. Position holes to avoid interference between the
LARGER
growth trays and ttings once installed.
Barbed
Hole diameters for both ttings is 1

Fitting
3
INSERT
FITTINGS
WITH WASHERS
AND ATTACH
LOCK NUTS
Hold bottom ange
when making
adjustments to
Strainer height.
Be sure to test all ttings & tubing connections in your set-up with
pump activated. Always run a complete ll and drain cycle to check
ll and drain rate and water levels before leaving unattended.
631-234-5261 www.dannermfg.com
UPPER FLOOD TABLE
FILL
RESERVOIR WITH PUMP
* Suggestion only.
Holes must be drilled to
work with YOUR set-up!
Fittings and Tubing will
have to t through or
around your method of
supporting the ood
table.
/ ".
1
4
4
ADJUST DRAIN FITTING
HEIGHT
LIFT
TWIST TWIST back
LOOSE to TIGHTEN
145 MM x 210 MM
DRAIN
/ "
1
4