Mercer Culinary M30725 Assembly Instruction Sheet

Assembly Instructions
Congratulations!
You are now the proud owner of a Mercer Magnetic Knife/Utensil Board. We are confident you will enjoy this board and it will be a welcome
addition to your kitchen so you can proudly display your knives and other kitchen utensils for years to come. These comprehensive instructions
were designed to guide you through the assembly process. Should you require further assistance, please do not hesitate to call 1-800-221-5202
and we will do our best to guide you further.
Take all items out of the box. Below is a list of components you will need to assemble the board.
Flat head bolt Nylon washer
Make sure to work on a surface which is smooth and free of anything which could scratch or cause abrasions to the board.
MERCER CULINARY | 1860 SMITHTOWN AVENUE, RONKONKOMA, NY 11779 | T 800.221.5202 | F 866.335.9700 | MERCERCULINARY.COM
Assembly Instruction Sheet
M30725/M30726
MAGNETIC KNIFE BOARDS
Allen wrench
Stainless steel base
Step 1
Take board with stem facing you and place the nylon washer on the end of the stem. The nylon
washer has a small hole which will line up with the small protrusion in the end of the stem.
Step 2
Pick up stainless steel base. The side with the silicone strips should be facing away from the
board. Align the protrusion in the stem with the small hole in the base and put these together.
The larger hole in the base should be centered over the threaded hole in the neck. Note: it
may be easier to have the board more perpendicular to the work surface. Two people may also
make this process easier.
Step 3
Thread the flat head bolt through the larger hole in the base and into the threaded opening in
the neck. Make sure this goes in smooth and does not cross-thread. Tighten by hand.
Step 4
Tighten the flat head bolt with the Allen wrench until tight.
Step 5
Turn the board right side up and put into place on your counter.
Magnetic board with neck
M99098 0518