Achim Home Decor GII Cordless Luna LUG227WH04 Installation Instructions

Installation Instructions for GII Cordless Luna 2-inch Vinyl Plantation Blind
STEP 1. Attach the Brackets
To install the end brackets, first determine where to
attach each bracket.
If you are installing an outside-mount blind on a
window (Fig. A), position the bracket on the window
frame or on the wall above the frame and attach
with the proper fasteners.
If installing outside-mount blind on a door (Fig. B),
position the bracket with a spacer block (not
included) on the door above the glass panel and
attach with screws. The spacer block must be
between the door and the bracket.
If installing inside-mount blind (Fig. C), position top
of bracket against inside surface of window frame
and attach as shown. Each end bracket uses at
least two screws. Make sure end brackets are level.
For the blinds over 32" wide and less than 45"wide,
a center support bracket will be provided. Blinds
larger than 45"wide will have two center support
brackets provided. To install the support brackets
(Fig. D) center the support bracket between the two
end brackets. Keep the top and back of each
support bracket level and aligned with the top and
back of the end brackets. If more than one support
bracket is used, space the support brackets evenly
across the width of the headrail. Insert screws in the
top for an inside mount; insert screws in the back for
an outside mount (Fig. D1).
Achim Home Décor's Family of Home Furnishings thanks
you for your most recent purchase. We are confident this
product will bring beauty and functionality to your home.
STEP 2. Install the Headrail
Position one valance clip at each end of the headrail, and
evenly space any additional clips across the width of the
headrail (Fig. E). Slide the headrail into the end brackets
and center support (Fig. F). Then close end bracket
covers until they click into place.
STEP 3. Install Valance
Your blind includes a valance (a slat). Put the valance
under the upper clap of each clip. Then bend and guide
the entire valance into the bottom clamps. (Fig G.)
STEP 4. Attach Hold-Down Brackets (Optional for
Door only)
To install the hold-down brackets, lower the blind all the
way down. Position bracket close enough to the bottom
rail so that the hold-down pin lines up with the hole and
the hold-down bracket (Fig. H). Attach the hold-down
brackets with screws. Insert the pins into the center of
each side of the bottom rail.
Achim Home Décor: 1-800-54-ACHIM
Customerservice@achimonline.com
OPERATING INSTRUCTIONS:
To Tilt The Blind:
• Rotate the wand in either direction to fully open
and close the slats to the desired angle.
To Lower and Raise The Blind:
• Tilt the slats to the fully open position first. (Parallel
with headrail).
• Grasp bottom rail firmly on both sides evenly and
pull down gently until reaching the desired length.
•To raise the blind, simply grasp both side of the
bottom rail and raise slowly to desired position.
TROUBLE SHOOTING:
Problem/uneven bottom rail:
Pull the blind down evenly on both side and adjust
both side when raising the blind up again.
Note: This blind cannot be shortened.