DataComm 50-3331-WH-KIT Instruction/Installation Sheet

DataComm Electronics 50-3331-WH-KIT & 50-3332-WH-KIT Flat Panel TV Cable Organizer Kits (Small & Medium)
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.datacommcableorganizer.com
Parts Included
1. Two (2) recessed cable plates
2. Two (2) low voltage mounting brackets
Tools Needed
1. Drywall saw
2. 6 Ft. tape measure
3. Pencil
4. Screwdriver
Use DataComm Electronics' new Small and Medium Flat Panel TV Cable
Organizer Kits to install low voltage cables behind your flat panel TV, (see
Figures 2 & 3), your amplifier or other audio and video devices. These
recessed low voltage cable plates are designed for use with Low Voltage /
Data cables "ONLY".
The 50-3331-WH-KIT and 50-3332-WH-KIT kits are designed to be used
with the enclosed single gang and double gang low voltage mounting
brackets (see Figure 1). The recessed cable plates can be installed
upright or upside down (see Figures 2 & 3 for upright installation).
Determine the location of your flat panel TV, amplifier or audio/video
device. Allow for location of the stud when cutting a hole in the wall to
install the low voltage mounting plate bracket. Using the enclosed
instructions, mount the low voltage mounting bracket in the opening you
have cut in the drywall. Then simply pull your audio/video cables through
the mounted low voltage mounting plate bracket and then through the
DataComm Electronics recessed cable plate. Insert the DataComm
Electronics recessed cable plate into your mounting plate bracket and
using the supplied wall plate screws, secure the wall plate tightly to
the wall.
These Recessed Cable Plates are Designed for Use
with Low Voltage / Data Cables "ONLY".
Do Not Run or Pull the TV Cord or Other Electrical
Cords Inside the Drywall. National Electrical Code (NEC) Does
Not Allow the Installation of the TV Power Cord or an
Extension Cord Behind the Wall.
CAUTION
Never install low voltage wiring during lightning storms.

Never install low voltage wiring in wet locations unless the

wire is specifically designed for wet locations.
Never touch un-insulated low voltage wires or terminals unless

the wire has been disconnected at its source.
Use caution when installing low voltage cables.

IMPORTANT INSTRUCTIONS
Read and understand all instructions.

Follow all warning and instructions marked on the product.

Do not use this product near water, for example near a bath

tub, wash bowl, kitchen sink, or laundry tub, in a wet basement,
or near a swimming pool.
SAVE THESE INSTRUCTIONS. Instruction sheets are available

online at www.datacommcableorganizer.com.
This product is patent protected by U.S. Patent
numbers D553475, D554475 and 7390964
RoHS Compliant
Instruction / Installation Sheet
50-3331-WH-KIT
Figure 1
Figure 3 - Back View
50-3332-WH-KIT
Figure 2 - Front View
4/02/15 Rev. 6