SR SUN RISE RE23 Installation Instructions

SHOWER FILTER INSTALLATION INSTRUCTIONS
What's this for?
—The instruction tells you how to start enjoying your new shower filter and quickly install.
—Match standard 1/2"threaded connector(the universal size in North America and Europe).
—For best results,keep water temperature between 39 and 176 ℉
Installation Guide
Remove
Shower
Arm
Mesh
Washer
Thank you for choosing this shower filter and we hope you enjoy using it.Please
take a few moments to read these instructions before installing the filter,and keep
them in a safe place for future reference.
Step1 : Rinse The Shower Filter
—Place the shower filter under a faucet and let the water
flush for about 20 seconds or until the water is clear.
Shower
—Then turn the shower filter upside down to flush it again.
Filter
Step2 : Remove Shower Head or Bracket
—Remove the existing shower head from the shower arm by
turning it counter-clockwise.
—OR if you have a hand shower,remove the shower bracket.
Step3 : Attach Shower Filter to Shower Arm
—Clean any excess material from the shower arm threads.
(Wrap tape around the threads 2-3 times if leak after install
the shower filter)
—Place shower filter (Upside with mesh washer) and hand
tighten to the shower arm by turning it clockwise.
Step4 : Attach Shower Head to Shower Filter
—Attach the shower head or bracket on to the shower filter,
then hand tighten by turning it clockwise.
—Turn on the water to check if it works normally.