NKCELL POWER JLBTD001 Manual

SPARE TIRE BRAKE LIGHT INSTALLATION STEP
STEP 1
Remove the third spare tire.
(Note: Be careful not to damage the camera in the
middle.)
STEP 4
Unplug the original plug of the car.
(Note: Pull out the pin as the pic shows first, and then
pull out the plug.)
Attention:
1.The product parts in this instruction may differ slightly from the actual product contents but generally does not affect the installation of the product.
2.Please feel free to contact your distributor if you have any kind of question about your purchase.
SPARE TIRE BRAKE LIGHT
COMPATIBLE WITH JEEP WRANGLER 2018-2023+JL/JLU
PLUG AND PLAY LOSSLESS INSTALLATION
Uasge:Spare Tire Wheel Brake Light
Voltage:12v DC
Color Of Light:Red
LEDs:405PCS
Waterproof:IP67
Diameter:13.8 Inch(350mmx350mmx23mm)
STEP 2
Remove all the screws of the third brake
light.
STEP 5
Insert the plug of the spare tire lamp into
the high brake lamp, the male plug into
the original plug, and place the plug as
the figure shown.
NKCELL POWER
STEP 3
Use a plastic screwdriver to separate the
plastic plate of the high brake light.
STEP 6
Install back the plastic plate of the high
brake light and tighten the screws.
Installation is complete.