DataComm 45-6001-WH-S Instruction/Installation Sheet

DataComm Electronics 45-6001-WH-S 1-Gang Recessed Cable Plate with Bracket
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.DataCommElectronics.com
• This product is designed for use with low voltage cables ONLY.
• DO NOT run or pull a TV cord or other electrical cords inside the wall.
• It is a violation of the National Electric Code (NEC) to run power cords or
extension cords behind the wall.
Parts Included
1. One (1) Recessed Cable Plate
2. One (1) Low Voltage Mounting Bracket
Tools Needed
1. Drywall saw
2. 6 Ft. tape measure
3. Pencil
4. Screwdriver
Use DataComm Electronics 1-gang recessed cable plate with mounting
bracket behind your flat panel TV, (see Figure 1), your amplifier or
other audio and video devices. The 45-6001-WH-S can be installed upright
or upside down.
Installing the Low Voltage Mounting Bracket
• Determine the location of your flat panel TV, amplifier or audio/video device.
• Hold the included low voltage mounting bracket with the face against the
wall in your desired location.
• Use pencil and trace the two flat sides of the bracket (see fig. 2)
• Rotate the bracket 180º, aligning start and end points from your first mark
and repeat previous step (see figure 3)
• Cut along the traced line with a drywall saw or utility knife.
• Insert low voltage mounting bracket into opening. Tighten down each of the
screws. As the wings tighten they will catch the back of the drywall, securing
the plate in place.
Installing the 1-Gang Recessed Cable Plate
• Run your low voltage cables through the low voltage mounting bracket.
• Pull cables through the recessed low voltage cable plate.
• Place the recessed low voltage cable plate onto the low voltage mounting
bracket and secure with the included screws.
CAUTION
Never install low voltage wiring during lightning storms.

Never install low voltage wiring in wet locations unless the

wire is specifically designed for wet locations.
Never touch un-insulated low voltage wires or terminals unless

the wire has been disconnected at its source.
Use caution when installing low voltage cables.

IMPORTANT INSTRUCTIONS
Read and understand all instructions.

Follow all warning and instructions marked on the product.

Do not use this product near water, for example near a bath

tub, wash bowl, kitchen sink, or laundry tub, in a wet basement,
or near a swimming pool.
SAVE THESE INSTRUCTIONS.

This product is patent protected by U.S. Patent
numbers D553475, D554475 and 7390964
RoHS Compliant
Instruction / Installation Sheet
g. 2
Figure 4
ETL LISTED
CONFORMS TO
UL STD. 1863
CERTIFIED TO
3026001
CAN/CSA STD. C22.2#182.4
Figure 1 - Front View
g. 3
Revised 09/02/2020