Park & Sun Sports PS-PVB Instructions

www.parksun.com
The support bases can be filled with water and/or sand. Position the bases on
either side of the pool playing area. Insert lower pole section securely into the
base. Adjust pole to desired playing height.
Insert the rope cable through the net clip on
the pole. Wrap top rope cable around the pole
and through the grommet hole in the top
corner of the net. Tie a double knot on the
backside of the grommet to keep the rope
from slipping. Tie the bottom net cords around
the lower power keeping the net sides parallel
to the poles.
If additional net tension or outward stability is
required, use the 15' adjuster cords and
ground stakes. Do not over tension the poles.
Keep the poles in a tight, upright position.
Note: net width can be adjusted to a shorter length by rolling excess netting onto
the support pole.
Adult assembly and supervision is recommended.
Pool Volleyball
• Telescopic PVC Poles (2pc.)
• Pole Support Bases
• 3' x 24' Net
• 5' Adjuster Cords
• 2-10" Plastic stakes
Height Setting Above Pool Side
• 34" - 38" & 42"
Base & Pole Set-up
Net Assembly
2150 S Tejon St • Englewood, CO 80110
office 303.935.8449 • fax 303.935.8872
800.776.7275