MoesGo B0B97G3B8G Troubleshooting

How to reconnect the f ingerbot?
. Make sure your phone's
mode.
. Long press the reset button on the Fingerbot until it blinks
three times.
.Then open the Smart Life APP and start pairing
How to solve the problem that Fingerbot often disconnects?
Fingerbot uses bluetooth point to point mode, so there are generally two reasons will cause frequent
disconnection:
1. the distance is far and there is a wall in the middle of the barrier, resulting in both sides of the bluetooth
signal is weak.
2. the phone has been connected to the bluetooth of other devices, such as already connected to the headset
or other devices, the bluetooth device can only support a single to a single, and can not support more than one
device online at the same time.
Solution:
1. When operating the fingerbot, try to keep no wall in between to keep the signal stable.
2. When you have connected other Bluetooth devices, you need to disconnect them before connecting the
fingerbot.
What can I do to fix the buttons on the Fingerbot that don't respond properly?
Reason:
1. It may be because the battery does not have enough power due to frequent use, or the replacement battery
does not meet the standard
2. Manual can not be controlled, may be the fingerbot lagging
Solution:
1. Check whether the purchased battery meets the standard of 5V 2A and replace the new battery for the
fingerbot again.
2. Try to reset the fingerbot, please long press the following position in the fingerbot until the device blinks
three times.
TROUBLESHOOTING
Bluetooth is turned on and in pairing