Better Living Products 76335-1 Installation Instructions

DISPENSER INSTALLATION INSTRUCTIONS
The Dispenser has been designed to be installed without damage to the wall surface and no tools
are required. When installed properly, the unit WILL NOT FALL DOWN!
Surface contaminants such as Dust or Dirt, Grease or Oil, Wax (especially prevalent on moulded
fibreglass shower surrounds, where it is used in the manufacturing process to release from the
unit), water, Detergent or Soap or their residue, loose particles or skin and body oils will prevent
the silicone adhesive from making a strong bond with the wall surface.
The most common way to solve a surface contaminant problem is to clean the surface:
Dry Clean: Dust or light contamination may be wiped clean with a dry cloth.
Wet Clean: In many cases a liquid cleaning agent such as solvents, acetone or isopropyl alcohol
(rubbing alcohol) is preferable. Make certain to select the right cleaning compound and allow
adequate drying time before proceeding with the installation.
1. You must use BOTH the double faced tape AND the
entire tube of silicone adhesive for your installation.
The tape must be there to hold the unit while the silicone
adhesive cures (in 24 hours). The tape alone will not hold
the unit, once it is filled.
2. Do NOT FILL the unit for 24 hours after installation.
The silicone can easily support much more than the weight
of the full Dispenser, but not until it has cured completely.
The curing time for this adhesive is 24 hours.
3. The wall surface where the unit is to be mounted must
be CLEAN and DRY! If the adhesive is bonding to
anything other than a clean, dry wall surface, the unit will
not stay on the wall. If any surface contaminants are
present, the adhesive tries to bond to the contaminants
resulting in an improper bond.