FOTING B0BNHYT92P Troubleshooting Chart

PROBLEM PROBABLE CAUSES
Motor will not
Fuse is blown.
run.
Pump did not pick up prime
through:
a. Improper priming.
b. Air leaks.
c. Leaking foot valve.
d. Water level below suction of
pump.
lmpeller plugged.
Motor runs,
Check valve or foot valve is stuck
but no water is
in closed position.
delivered.
Pipes are frozen.
Foot valve and/or strainer are
buried in sand or mud.
Low line voltage.
Lift too high for pump.
Improper hose.
Lift too high for pump.
Pump does not Low votage, speed too slow.
deliver
Offset piping is too small in size.
rated capacity.
Impeller or discharge pipe is
clogged.
No check valve in long discharge
pipe alowing liquid to drain back
Pump cycles
into sump.
continualy.
Check valve leaking.
Basin too small for inflow.
Leaks from pump body.
Pump leakage
Leaks from hose connection.
TROUBLESHOOTING CHART
CORRECTIVE ACTION
Replace fuse.
reprime.
Clean impeller.
Replace check valve or foot valve.
Thaw pipes. Bury pipes below frost line.Heat
pit or pump house.
Raise foot valve and/or strainer above water
source's bottom.
If voltage under recommended minimum,
check size of wiring from main switch on
property. If OK, contact power company.
Check rating table.
Use the suitable hose and hook up tightly.
Check rated pump performance.
Check for proper supply voltage to make
certain it corresponds to nameplate voltage.
Use larger offset piping.
Pull pump and clean. Check pipe for scale or
corrosion.
Instal a check valve in discharge line.
Inspect check valve for correct operation.
Instal larger basin
If yes, pump is releasing air from ant-alrlock
gap, just fully submerge and run pump for a
while, leakage wll be Improved by itself.
If yes, use PTFE sealant tape and screw
tightly; Otherwise considerhose or connector
defective
a.Reprime.
b.Check hose connections
c.Replace foot valve.
d. Lower suction line into water and