Advertisement
Advertisement
Table of Contents
Related Manuals for TACKLIFE PID01A
Summary of Contents for TACKLIFE PID01A
- Page 1 User Manual Hammer Drill PID01A...
-
Page 2: General Safety Instructions For Electric Tools
Overview 1. Drill chuck 2. Second handle 3. Switch for percussion drilling/drilling 4. Direction switch 5. Locking button 6. Operating switch with speed regulator wheel 7. Drill chuck key General Safety Instructions for Electric Tools This device is exclusively for private use! It is not fit for commercial use! Warning: when working with electrical devices the following prevention and safety Instructions are to be observed to avoid fires, electric shocks and physical injuries: For safe working:... - Page 3 In case of extreme application conditions (e.g. high humidity, presence of metal particles, etc.) the electrical safety of the device can be improved by connecting an isolation transformer or a fault current circuit breaker! Keep children away! Do not let other people touch the tool or the cable! Keep other people out of the working area! Make sure that the tool is stored safely! Unused electric tools are to be kept in a dry, highflying or closed place, out of the reach of children!
- Page 4 Pull the plug out of the socket after use, before maintenance and when changing accessories such as saw blades, drills cutters, etc.! Do not leave protruding tool keys! Make sure before turning on the tool that the key or setting gauge is removed! Avoid the accidental starting of the tool! Never carry an electric tool connected to the power mains with your finger on the switch!
-
Page 5: Special Safety Information
Special Safety Information When drilling or screwing into walls, ceilings etc make sure beforehand that you will not damage any hidden electric cables. During this work you should not touch any metal parts of the machine. Only touch the machine by the plastic housing. Your machine is double insulated. -
Page 6: Drilling Tips
First remove the mains supply from the socket. Turn the ring of the drill chuck (1) until the clamping jaws are open wide enough. Insert the drill into the clamping jaws of the drill chuck (1). Insert the end of the drill chuck key (7) into one of the three holes on the body of the drill chuck (1) and let the head of the key (7) lock into place in the ring of the drill chuck (1). -
Page 7: Technical Data
Overload Never use excessive force when drilling. Too much pressure reduces the speed of the machine, and the required power is greatly reduced. This may result in overlo which can damage the motor of the drilling machine. When the drilling machine becomes too hot, allow it to run for two minutes without a load and then interrupt working for a short time. - Page 8 516-896-6611 Mon-Fri 9AM-5PM(ET) www.engindotools.com www.facebook.com/EnginDotOfficial support@engindotools.com Distributor: Shenzhen Houqianding Trading Co., Ltd. Address:Room 504D, Block B, Sunshine Hotel, No.2003, Jiabin Road, Jianan Community, Nanhu Street, Luohu District, Shenzhen...
Need help?
Do you have a question about the PID01A and is the answer not in the manual?
Questions and answers