Ebode XDOM RPT - PRODUCTSHEET User Manual page 7

Plug-In Transceiver Module
Reset appliance module addresses
1. Use a small sharp object, e.g. a paper clip, to press and hold the
setup button until the green led turns on. (about 3 or 4 seconds)
2. Release the button, the led will blink red and green and then
turn off.
3. When the red and green LEDs are off, the module is reset.
Operating the RPT Module
Functions enabled by a wireless transmitter (EM, TPC, IMRF, etc..)
ON / OFF key
Turns the lamp or appliance On & Off
Tips
- Knowledge base available on www.ebodeelectronics.eu.
Can I plug transceiver module into a power strip?
This is no problem with a simple power strip however you can not use the module
with a surge protected power strip.
The transceiver is not responding to RF commands?
- Check and/or change the remote control battery.
- Reset the transceiver (see paragraph 4) and reprogram the address.
- Then, proceed again using learning mode as explained in 2.
The RPT does not respond to command sent via the power line?
- Reset the RPT (see paragraph 3) then initialize the address.
- Then, proceed again using learning mode as explained in 2.
July 2009 page 7
Ref : RPT
RPT