Page 1
4.9 CU.FT. BEER KEG COOLER INSTRUCTION MANUAL Model No.: MCKC490B To ensure proper use of this appliance and your safety, please read the following instructions completely before operating this appliance.
TABLE OF CONTENTS Names of the Parts _________________________________________________3 Important Safety Instructions ________________________________________ 4 Installation Instructions _____________________________________________ 4 Before Using Your Beer Dispenser ____________________________________ 4 Installation of Your Beer Dispenser ________________________________ 4 - 5 Electrical Connection _______________________________________________ 5 Installation Instructions for Beer Keg_______________________________ 6 - 9 Dispensing of Beer _________________________________________________ 9 Operating Your Beer Dispenser _____________________________________ 10 Setting the Temperature____________________________________________ 10...
NAMES OF THE PARTS MODEL NO.: MCKC490B Beer Tower Plastic Gasket Safety Guard Rail Drip Tray Adjustable Thermostat Regulator Gas Cylinder Gas Cylinder Support Evaporator Reversible Door Beer Keg (not included) Metal Plate Metal Washers(2) Castors with Lock (4)
IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electrical shock, WARNING or injury when using your Beer Dispenser, follow these basic precautions: Read all instructions before using the unit. • WARNING: Risk of child entrapment. • To avoid the possibility of child entrapment, please take the following precautions •...
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the Beer Dispenser not to perform properly. This unit is not designed for outside installation (ie garages, porches, etc.) Avoid locating the Beer Dispenser in excessive humidity.
INSTALLATION INSTRUCTIONS FOR BEER KEG Keg Installation Sketch · Install the four castors with lock provided into the unit’s bottom (four screw holes pre-supplied) The two metal gaskets are used for the front two Castors. Figure (1) before installation. Figure (II) is the final version.
Page 7
Installation Of CO Cylinder Support Install the metal support provided onto the 4 studs located on the exterior back wall. Align the • holes in the support with the studs and push down firmly. (See Figure 1) Installation Of CO Cylinder The CO Cylinder does not come filled.
Page 8
Installation Of The Beer Keg Position the beer keg directly in front of the open door. Using keg handles only, carefully lift the • beer keg. (See Figure 5) To place the beer keg inside the cabinet, brace your knees behind the beer keg. Lift the front of •...
Spanner Faucet Wrench Spanner faucet wrench is provided for either removing or tightening connection Plastic Faucet Lever Attach the black plastic lever (pull handle) to the top of the faucet by tightening it by hand clockwise until the end, holding in the silver nut underneath so it does not turn.
OPERATING YOUR BEER DISPENSER Setting The Temperature To start, turn the temperature control knob to the maximum setting (6). Allow the unit to run for 24 hours for the unit to cool properly. You may then adjust the temperature to the desired setting. In average room conditions of 70°F (21 ºC), set thermostat knob position between “4”...
CHANGING THE REVERSIBLE DOOR This Beer Dispenser has a door that can be set to open from the left or right side. The unit is delivered to you with the door opening from the left side. To reverse the opening direction, please follow the instructions below.
CARE AND MAINTENANCE Cleaning Your Beer Dispenser Turn the temperature control to "OFF", unplug the Beer Dispenser, and remove the contents. • Wash the inside surfaces with a warm water and baking soda solution. The solution should be • about 2 tablespoons of baking soda to a quart of water. Wash the shelves and stand with a mild detergent solution.
TROUBLESHOOTING GUIDE You can solve many common Beer Dispenser problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. PROBLEM POSSIBLE CAUSE Beer Dispenser does not operate. Not plugged in.
MC Appliance Corporation. Model Parts Labor Compressor Type of Service (Part Only) MCKC490B One-Year One-Year Five Years In-Home For Service or Assistance please call 888 775-0202. Or visit us on the web at to request warranty service or order parts.
Need help?
Do you have a question about the MCKC490B and is the answer not in the manual?
Questions and answers