Advertisement
Quick Links
Advertisement
Related Manuals for Nouveau FD-40M
Summary of Contents for Nouveau FD-40M
- Page 1 Fan Pedestal 40cm Chrome This manual applies to the following products SKU: 361425 / Model: FD-40M...
- Page 2 Table of Contents Important Safety Instructions Description of Parts Assembly Operation instructions • Oscillation and Angle adjusting • Height adjustment • ON/OFF and Speed selection Cleaning and Maintenance Please read this manual carefully before use, and keep for further guidance...
- Page 3 Important Safety Instructions This appliance can be used by children aged from 8 years and above if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved. Cleaning and user maintenance shall not be made by children unless they are aged from 8 years and above and supervised.
- Page 4 It is recommended to unplug the fan from the mains socket when not in use. Always remove from the mains socket before cleaning. The supply cable cannot be replaced. If the cable is damaged the appliance should be scrapped. Do not let the cable hang over the end of a table or work surface or touch hot surfaces.
- Page 5 Description of Parts Front Guard 2. Locking screw 3. Fan Blade 4. Rear Guard 5. Front Guard Nut (x1) 6. Telescopic Stand 7. Pivot knob 8. Retaining screw 9. Motor housing 10. On/Off/Speed Control Oscillating Control Motor Spindle Fan Blade Retaining Screw (x1) Guard Retaining Clips Stand Base Weight...
- Page 6 2. Next attach the motor housing (9) to the top of the telescopic stand (6).First remove all the screws, etc.(7, 8, 19 & 20) from the motor housing bracket. 3. Place the motor housing on the top of the stand and thread the large pivot bolt (20) through the bracket and screw in the small retaining screw (8) and tighten (but do not over tighten).
- Page 7 Identify the top of the Back guard - the handle is at the top. Fit the back guard onto the motor body with the handle at the top and secure it with the four guard fixing screws. Handle 6. Fitting the fan blades •...
- Page 8 • Place the fan blades onto the spindle with the screw on the fan shaft facing upwards. The tip of the screw must rest on the flat on the drive shaft. • Align the fan with the end of the motor spindle (arrowed), then use a long screwdriver to tighten the fixing screw onto the shaft.
- Page 9 • Check that the guards are clamped together by all five clamps. • Fully tighten the small screw and nut. Your fan is now ready to use. Operating Instructions 1. Set the fan on a dry, level and sturdy surface. 2.
- Page 10 • ON/OFF,Speed Selection Adjust the desired speed by oscillate the power switch: 0--- Stop I--- Low II--- Medium III--- High Cleaning And Maintenance Your fan requires little maintenance and contains no user serviceable parts. Do not attempt to dismantle the Fan Motor body yourself. The fan is permanently lubricated and will not require additional lubrication.
Need help?
Do you have a question about the FD-40M and is the answer not in the manual?
Questions and answers