Summary of Contents for Monster Power MP10PB
- Page 1 MONSTER .co.za POWERBANK CAR JUMP STARTER For 12V Petrol and Diesel Vehicles MP10PB 10,400mAh 600Amps USER MANUAL...
-
Page 2: Warranty
BATTERY HEALTH Cycle the battery every 3 months. Use the powerbank from time to time to discharge and charge the battery (charge a few devices), this ensures battery health and longevity of the Monster Power. - Page 3 General Info rmation This product is capable of starting 12V petrol engines up to 6.0L and diesel engines up to 3.0L. Capacity: 10,400mAh 38.48 Wh Dimensions: 158 (L) x 75 (W) x 31mm (H) Input charging: Output: USB Jump Start - 1 2V Start Current: Peak Current: C ycle li fe: 1,000 cycles...
- Page 4 Safety Information Please read this entire manual before attempting to use the product. WARNING 1. Do not damage, drop or crush this item. Do not attempt to use this item that has been dropped, punctured, run over or damaged in any way. 2.
- Page 5 Product Features 1. Flashlight 2. Battery terminal socket for the jump start leads 3. LED display 4. 5.0V/1.0A Output 5. Power button 6. 5.0V/2.1A Output 7. 18V/1A Input 8. Power ON/OFF Note: The jump start LED display will shut down after 20 seconds of inactivity. Press the power button (5) to reactivate.
- Page 6 Package Contents Jump Starter Smart Battery Cable In Car Charger 3 in1 data lines Protective Carry Case Functions on Smart Battery Cable 1) Reverse polarity connection: Solid Red LED with fast 2 short beep. 2) Short-circuit protection: Solid Red LED with long beep (Beeping as 3.3Hz Frequency) 3) Over-heat protection: Solid Red LED with Long beep (Beeping as 2Hz Frequency)
- Page 7 Quick Guide I. Jump Starting Vehicles Before attempting to jump start your vehicle, please read your vehicle owners manual to insure there are no specific steps needed. DO NOT crank the engine for more than 4 continuous seconds while the unit is connected to the vehicle.
- Page 8 II. Charging Electronic Devices (1) For Cell Phones/Tablets 1st step: 2nd step: Choose a cable to suit your device Insert the USB charge cable into one of the three (3) smart output connections 3rd step: 4th step: Insert the other end of the cable into the Turn on/off switch to the ON position then device being charged press...
-
Page 9: 7, Trouble Shooting
IV. Flashlight Operation Turn the on/off switch to the “ON” position Press and hold for 5 seconds to start flashlight Press again to shift to SOS flashing Press again to turn off the flashlight Trouble Shooting Problem Cause Solution No response Low voltage Charge the unit with home when pressing the... - Page 10 • All warranty claims are limited to repair or replacement of the defective product and at the sole discretion of Monster Power. • If we replace the product, the product will be covered for the remaining time of the original warranty period.
- Page 11 MONSTER .co.za Don’t forget to complete the online warranty form to make sure you are covered with the one year warranty. Visit the url below and complete the online form. www.monsterpo wer.co.za/warranty If this battery lays dormant for 6 months it needs to be discharged and then recharged.
- Page 12 Caution: Please read the user manual carefully! MONSTER .co.za www.monsterpower.co.za...
Need help?
Do you have a question about the MP10PB and is the answer not in the manual?
Questions and answers