TecLINE T-1 Instruction Manual

DIVING TORCH TECLINE T-1
INSTRUCTION MANUAL
Thank you for choosing the Tecline T-1 diving torch.
If you have additional questions about the torch described in this manual please contact us by email: scubatech@scubatech.pl.
PURPOSE
The Tecline T-1 diving torch is designed for underwater use as a backup light.
The built-in overheating protection system allows the torch to be used above water as well, making the Tecline T-1 a durable
light for home and car use.
USE / CHARGING THE BATTERY
Charging 21700 batteries
-Unscrew the head of the torch by turning it counterclockwise.
-Plug the USB-C charging cable into the port on the flashlight body.
-After charging, screw the head onto the flashlight body clockwise until fully tightened, but without applying excessive force.
Turning On/Off
• To turn the torch on or off, press and hold the control button until the light switches on or off.
• Light modes: full power, 50%, and 20% – change modes by pressing the button once briefly.
• Double-pressing the control button activates SOS mode.
SAFETY INFORMATION / RECOMMENDATIONS FOR THE BATTERY
!) Never point the light beam directly at the eyes. The torch beam can cause permanent eye damage.
!) Do not leave the torch switched on without supervision.
!) Never unscrew the battery compartment cap while underwater. This will flood the battery chamber and may result in damage
to both the torch and the batteries. Such damage is not covered by the warranty.
Do not take the torch underwater with low batteries. Do not mix charged and discharged batteries.
WARNING!
THIS TORCH IS DESIGNED TO OPERATE ONLY WITH USB-21700 BATTERIES . USING OTHER TYPES OF BATTERIES MAY DAMAGE
THE TORCH AND SUCH DAMAGE IS NOT COVERED BY THE WARRANTY.
1/2
www.teclinediving.eu