TecLINE STROBE-LIGHT-MINI Instruction Manual

DIVING TORCH TECLINE STROBE-LIGHT-MINI
INSTRUCTION MANUAL
Thank you for choosing the Tecline STROBE-LIGHT-MINI diving torch.
If you have additional questions about the torch described in this manual please contact us by email: scubatech@scubatech.pl.
PURPOSE
The Tecline STROBE LIGHT MINI dive light is designed for use both on the surface and underwater, as a colored marker for
position signaling. It is available in blue, white, green, red, and yellow light versions.
USE / BATTERY INSTALLATION
Battery installation
- Unscrew the flashlight head counterclockwise.
- Remove the depleted AAA battery and replace it with a new one. Insert the battery according to the polarity sticker indicating
+ / –. The positive end should face the flashlight head.
- Screw the head back on clockwise until fully tightened, but do not use excessive force. Tightening turns the light on – to turn it
off, unscrew the head about ¼ turn.
Turning On/Off
• To turn on the flashlight, tighten the head clockwise.
• To turn off the flashlight, loosen the head by ¼ turn counterclockwise.
• To activate strobe mode, turn the flashlight on, then immediately off and on again.
SAFETY INFORMATION / RECOMMENDATIONS FOR THE BATTERY
WARNING – Strobe Mode:
Do not look directly at the flashing light – it may cause dizziness, disorientation, or, in sensitive individuals, even an epileptic
seizure.
!) Do not leave the torch switched on without supervision.
!) Never unscrew the battery compartment cap while underwater. This will flood the battery chamber and may result in damage
to both the torch and the batteries. Such damage is not covered by the warranty.
Do not take the torch underwater with low batteries. Do not mix charged and discharged batteries.
WARNING!
THIS TORCH IS DESIGNED TO OPERATE ONLY WITH AAA BATTERIES . USING OTHER TYPES OF BATTERIES MAY DAMAGE THE
TORCH AND SUCH DAMAGE IS NOT COVERED BY THE WARRANTY.
1/2
www.teclinediving.eu