Summary of Contents for TOLSEN TOOLS 10501
- Page 1 10501 ANGLE GRINDER STAND 115mm/125mm INSTRUCTION MANUAL SAVE THIS MANUAL ! You will need this manual for safety instructions, operating procedures and warranty. Put it and the original sales receipt in a safe dry place for future reference.
- Page 3 Introduction Please read the manual thoroughly before bringing this device into service. If the device was damaged in transit, do not install or use it and contact your dealer. Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will not accept responsibility for any ensuing defects or problems.
- Page 4 ASSEMBLY 1. Fix stand (2) onto base (1) with washers (3) and tighten with screws (4). 2. Fix the top/bottom adjusting screws (7) and (13) at the top/boltom holes of stand respectively. 3. Fix twa angle grinder holders (14) and round plastic ring (15) onto the stand by tighten screws (5). 4.
Need help?
Do you have a question about the 10501 and is the answer not in the manual?
Questions and answers