Subscribe to Our Youtube Channel
Summary of Contents for Solartronics SP-A11MS1-01
- Page 1 Operating instructions for power distributor SP-A11MS1-01 SP-A11MS1-02 SP-A6MC-P015 SP-1605A SP-615/3*415 SP625/3*425 ST-3*415-P015C ST-P015-3*H212...
- Page 2 SP-A11MS1-02 SP-A11MS1-01 SP-A6MC-P015 SP-1605A SP-615/3*415 SP-625/3*425 ST-3*415-P015C ST-P015-3*H212...
-
Page 3: Proper Use And Handling
1. Introduction It is very important to read these operating instructions carefully and to keep. Please pay attention and follow all of them Instructions. This user manual requires thorough and comprehensive Reading. It is an indispensable part of the recently acquired ower distribution board and contains important instructions for installation, operation and handling. -
Page 4: General Safety Information
3. Protection class The power distributors comply with protection class IP 44 in accordance with din EN 60529 (VDE 0470-1), provided the intended use is observed. The Details are described in the “Commissioning” chapter. The IP 44 classification means in detail: IP 4X: Protection against solid foreign objects with a diameter of at least 1.0 mm, such as wire. -
Page 5: Installation Instructions
5. Installation instructions The assembly, dismantling, installation, commissioning and maintenance of the The device may only be used by a qualified electrician be performed. This professional must meet the following criteria and take into account: Guaranteeing the intended use of the device. Follow the assembly and operating instructions. - Page 6 7. Delivery and return of packaging Transport test: Please carefully check the completeness and condition of yours Delivery. If you notice any damage during transportation or the If the delivery is incomplete, please inform your dealer immediately. Packaging note: The materials from which the packaging is made are valuable Raw materials and can be recycled.
- Page 7 When a device is plugged in, only pull the plug on it Plug housing from the socket. Avoid pulling out the plug on the cable. Make sure that the cables are not kinked or pinched or overheated and not in contact with heat sources come outside.
- Page 8 Test residual current circuit breaker (Fig.: D) (for SP-A11MS1-01): Checking the residual current circuit breaker (FI/RCD): Some power distributors are equipped with residual current circuit breakers (FI/RCD). which must be regularly checked for functionality. The test is carried out in a no-load state by pressing a Test button, causing the circuit breaker to trip.
-
Page 9: Instructions For Cleaning And Maintenance
11. Instructions for cleaning and maintenance. Depending on the environmental conditions and the degree of pollution The device can be cleaned either dry or damp. It will Recommended dry cleaning at regular intervals to prevent stubborn dirt. Before cleaning: Please remove all connected ones first Consumers from the device, as described in the “Operation”... -
Page 10: Decommissioning, Storage And Disposal
12. Decommissioning, storage and disposal Working on live components can lead to DANGER: serious injury or even death. Please note Follow these steps before any work: Remove all plugged-in consumers. Turn off all safety devices. Disconnect the supply line from the mains. Storing the device: To ensure proper storage and to enable trouble-free operation later, please note lease the following points:... - Page 11 cause. Only switch a protective device on again after after you have switched off or disconnected all connected consumers Have disconnected the power distributor. Procedure in the event of loss of power to a connected Consumer: If one of the connected consumers no longer has voltage is supplied, proceed as follows: 1.
-
Page 12: Environmental Conditions
14. Environmental conditions To ensure safe and trouble-free operation of the device, The following environmental conditions should be observed: The device should be used without prior consultation with the manufacturer not in an additional housing or in a building niche be installed.
Need help?
Do you have a question about the SP-A11MS1-01 and is the answer not in the manual?
Questions and answers