BlissLights SKY Lite Manual

INTRODUCTION

Thank you for purchasing the BlissLights SKY® Lite Laser Galaxy Projector. This product is a unique indoor light fixture that uses patented laser and holographic technology to project thousands of moving pin-points of light against a transforming nebula cloud. Sleep under the stars, create a romantic starlit dinner, or take your home entertainment center to the next level. We hope you enjoy this incredibly unique lighting experience.

Each unit provides up to 30 x 30 ft of coverage. It has maximum electrical usage of less than 5 Watts and operates in temperatures between 14°F to 95°F (-10°C to 40°C).

BEFORE YOU BEGIN

Immediately upon receiving the fixture, carefully unpack and check the carton contents to ensure that all parts are present and in good condition. Notify the retailer immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling. Save the carton and all packing materials. In the event that the fixture must be returned, it is important that the fixture be returned in the original factory box. Please see parts list below for box contents.

PARTS LIST:

1. Laser Projector
2. USB-C Power Cord
3. Power adapter

Please note: Included adapter may vary from picture shown.

SETTING UP THE LASER PROJECTOR

1. Remove protective film sticker from laser aperture.
2. Insert the USB power cord into a powered USB port or use the included wall adapter to connect to an available electrical outlet. It is best practice for users to connect the power adapter to the wall before connecting the device to the power adapter.
3. Place the Sky® Lite on a flat solid surface and aim toward desired ceiling/wall.
4. Press the power button. The nebula and laser stars will gradually illuminate and begin moving by default.
5. To adjust the illumination angle for walls, tilt the light forward onto the secondary support panel.
6. To turn off the light, cycle through the power button modes until the unit turns off completely. Remove the power plug from electrical outlet.
7. Use the following buttons to control lighting effects:
   

DEFAULT SETTINGS

Once the laser projector is plugged in, it will enter the default mode where all effects are on. Use the buttons to change the effect settings and brightness. This light has a built-in timer that is designed to automatically shut off after 6 hours of operation.

INSTALLATION TIPS

• Do not connect the light to a dimmer pack, as a dimmer accessory may damage the laser component.
• Use only the manufacturer-provided CUL power supply.
• Limit the use of extension cords. If you need an extension cord, use only UL, CUL, or CSA approved 3rd party extension cords.
• The darker the display area, the brighter your projection will appear. Try to avoid display areas with strong ambient light sources, such as commercial street lights or bright security flood lights.

PRODUCT SPECIFICATIONS

Laser Classification	Class 2
Laser Color	Blue - 445nm, Green - 510nm ± 5nm
Nebula Cloud Color	Blue - 450nm
Housing	ABS plastic
Power consumption	Less than 5 W
USB Power Adapter Input	100-240 V ~ 50/60 Hz, 0.2 A
USB Power Adapter Output	5V 1A
Operation	Indoor
Operating Temperature	14°F to 95°F (-10°C to 40°C)
Projection Coverage	Laser - 30 x 30 ft Nebula cloud - 15 x 15ft
Maintenance	Maintenance Free
Dimensions	6.5"L x 2.5"W x 6.5"H
Cord Length	5 ft (1.5 m)

For detailed warranty information for your country, please visit www.blisslights.com/warranty

This is not a toy. Young children must be supervised while using this device at all times. This unit is not waterproof. Use and store indoors or in a dry place.

CLEANING INSTRUCTIONS

Surface clean only with a soft, dry cloth. Unplug unit before cleaning.