Page 5
Echo RO™ Accessory Box ⅜ in. T-Valve User Manual SMPS 24V4A Power Adapter with a non-grounded American plug Drain Clamp with ¼ in. Quick Connect Tubing • 5 ft. of white ⅜ in. Tubing • 5 ft. of blue ¼ in. Tubing •...
HOW TO INSTALL THE ECHO RO™ SYSTEM Install T-Valve and Source Water Valve 1. Shut off the cold water 3. Wrap threads of the 2. Detach the cold valve. waterline from Source Water Valve and the cold water T-Valve with Teflon tape valve.
Page 7
4. Push the red Tubing 5. Push the red Tubing into the ¼ in. hole and into the elbow on the secure with a Locking back of the Echo RO™ Clip. and secure Tubing with a Locking Clip.
Page 8
HOW TO INSTALL THE ECHO RO™ SYSTEM Install & Connect to Echo RO Faucet™ Please see Echo RO Faucet™ installation guide included in the Echo RO Faucet™ box. Final Steps 1. Reopen the cold water 2. Turn the T-Valve switch valve.
Warranty will be Voided. When in use, the Echo RO™ begins dispensing water and the display shows a real-time count of Total Dissolved Solids (TDS) in parts per million (PPM) before and after filtration. The display also shows the Filter Life Indicator and the Power indicator light.
FILTER CARTRIDGE REPLACEMENT Filter Reminders There are 6 lighted rectangles on the display representing the lifespan of each Filter. The lights will extinguish one at a time as the Filter is used. When no rectangles are lit, the Filter’s lifespan is over. Recommended Replacement Period for Filter Cartridges STAGES FILTER CARTRIDGE...
Page 11
How to Replace Cartridges 2. Unplug the Echo 1. Turn on the Option 1 Option 2 RO™. water and drain This can be done Manually flush the water from without turning the Echo RO™ off the Echo RO™ the Echo RO™ to...
Page 12
Filter Reset After Replacement secs 1. Press Select for 2. Keep tapping Select 3. Press the Reset 3 seconds to enter until the correct Filter button. The Filter Life selection mode. is selected. Indicator rectangles will be lit again. NOTE Selection mode will exit automatically if there is no operation for 5 seconds.
TROUBLESHOOTING GUIDE ISSUE CAUSE SOLUTION Water pump is out of Insu cient source Increase source water service and the Echo RO™ water pressure. pressure. does not dispense water. No power or power Check for the light on the failure. Power Adapter. If there is no light and the Echo RO™...
Source-water pressure: 0.1 to 0.04 MPa Electric shock resistance: Type II SAFETY PRECAUTIONS When the Echo RO™ is not going to be in Replace Cartridges according to the use for an extended period of time Filter Life Indicator. (overnight, when user is on vacation, Only use the Power Adapter that etc.), turn off the Source Water T-Valve...
Need help?
Do you have a question about the EchoRO and is the answer not in the manual?
Questions and answers