1.2 Intended Use The ibidi Air Pressure Generator is approved by ibidi GmbH to be used as a source for pressurized air for the Gas Mixers of the ibidi Gas Incubation Systems. The ibidi Air Pressure Generator can be used as alternative to laboratory lab lines or gas bottles for pressurized air to operate the ibidi Gas Mixers (please see instructions of the ibidi Gas Incubation Systems).
The suitable line voltage and frequency is also indicated on the bottom plate of the pump. 1.5 Disclaimer • ibidi shall not be held liable, either directly or indirectly, for any damage incurred as a result of product use. Version 1.1 (March 10, 2023)
• Avoid dust and corrosive gas. Do not install the ibidi Air Pressure Generator where it could be exposed to high levels of dust or to outside air or ventilation outlets.
Air Pressure Generator 1.7 Waste Disposal – WEEE The ibidi Air Pressure Generator must be disposed of in compliance with the WEEE Directive 2012/19/EC. This symbol on the product is in accordance with the European Union’s Waste Electrical and Elec- tronic Equipment (WEEE) Directive.
3. Connect the blue gas tubing of the ibidi Gas Mixer to the ibidi Air Pressure Generator (to the sterile filter or directly to the push-in fitting) and to the ”Air” input port at back of the ibidi Gas Mixer (Figure 1B, C).
Air Pressure Generator Figure 1: Connection of the ibidi Air Pressure Generator to the gas tubing of the ibidi Gas Mixer. See description A, B, C in the text above. Figure 2: How to connect and disconnect the gas tubing to the push-in fittings of the ibidi Air Pressure Generator and the ibidi Gas Mixer.
Change the prefilter at the air inlet in the base plate when dirty (Figure 3). Figure 3: Exchanging the prefilter in the base of the ibidi Air Pressure Generator. To exchange the prefilter in the base plate of the ibidi Air Pressure Generator, perform the following steps in the indicated order: 1.
Need help?
Do you have a question about the 11928-230 and is the answer not in the manual?
Questions and answers