Advertisement
Quick Links
INSTRUCTIONS FOR OCEAN SIGNAL PLB3
How to Fit an Ocean Signal PLB3 to the Atlas 190 UML Life Jacket
These instructions will guide you through fitting your device into an Atlas lifejacket. Follow each
step carefully to ensure it functions safely and correctly. Handle the lifejacket and all device
components with care to avoid damage during installation.
Many users of this PLB carry the device in a jacket or snug pocket. However, a tether should
always be used to prevent loss at sea.
Refer to Fig. 8 for guidance on securing the device to your lifejacket after activation.
Before You Begin
Make sure you're familiar with how your Personal Locator Beacon (PLB) works—especially how to
disable and re-enable it. You'll need to do this during the fitting process. If unsure, please refer to
your Original Equipment Manufacturer's (OEM) manual.
You will need a sharp pair of scissors and a flat surface to work on.
Step 1: Open the Lifejacket
Open your Atlas lifejacket via the burst point and peel the cover apart to expose the inflatable
bladder. Spread the bladder out flat, being careful not to catch or snag the manual inflation cord.
For more details on unpacking, refer to your user manual.
Step 2: Cut the Lower Slot
Using scissors, carefully cut the lower slot along the dotted line. Be sure not to cut or damage the
inflatable bladder.
(See Fig. 1)
Advertisement
Related Manuals for Ocean Signal PLB3
Summary of Contents for Ocean Signal PLB3
- Page 1 INSTRUCTIONS FOR OCEAN SIGNAL PLB3 How to Fit an Ocean Signal PLB3 to the Atlas 190 UML Life Jacket These instructions will guide you through fitting your device into an Atlas lifejacket. Follow each step carefully to ensure it functions safely and correctly. Handle the lifejacket and all device components with care to avoid damage during installation.
- Page 2 Fig 1. Step 3: Deactivate the Device Refer to the OEM User Manual for your PLB and follow the steps to deactivate the device before continuing. Step 4: Secure the Activation System Refer to your OEM User Manual and follow the steps to secure the activation system. Make sure to tie the cord and required components as instructed.
- Page 3 (See Fig. 2a, 2b, and 2c) Fig 2a. Fig 2b. Fig 2c.
- Page 4 Step 5: Attach the Device Slide the fitting clip into the upper slot (Fig. 3a). Then, insert the end of the device through the lower slot (Fig. 3b) and mount it on the fitting clip. Fig 3a. Fig 3b. Step 6: Tie the Cords Together Using figure 8 knots (Fig.
- Page 5 Fig 4a. Fig 4b. Step 7: Arm the Device and Secure Components Follow the instructions in the PLB’s OEM User Manual to stow the antenna and arm the device. Slide the clip into place and apply the tape to secure it (Fig. 5a). Make sure the plastic guard is properly secured (Fig.
- Page 6 Fig 5a. Step 8: Secure the Tape Thread the loose end of the tape through the far end of the bladder panel and tie a secure knot. Ensure there is exactly 12 cm (4.7”) of space between the knot and the clip. (See Fig.
- Page 7 Fig 6a Fig 6b Step 9: Repack the Lifejacket Repack the lifejacket as outlined in the Atlas manual—except make sure the device is folded on top, facing outward, and positioned as the uppermost layer above the bladder. (See Fig. 7)
- Page 8 Fig 7 Step 10: Mark the Label As a final step, locate the label tucked into the centre back panel of the lifejacket and mark it to indicate "PLB fitted." (Fig 8)
- Page 9 Fig 8...
Need help?
Do you have a question about the PLB3 and is the answer not in the manual?
Questions and answers