Stereo Specifications - Crown D-60 Instruction Manual

1.2 SPECIFICATIONS
1.2.1 STEREO SPECIFICATIONS
Output Power
Frequency Response
1 KHz Power
Harmonic Distortion
1.M. Distortion
(60Hz-7KHz 4:1)
Slewing Rate
Damping Factor
Output Impedance
Load Impedance
Voltage Gain
Input Sensitivity
Output Signal
35 watts per channel minimum RMS (both channels oper-
ating) into an 8 chm load over a bandwidth of 20Hz-20KHzata
rated RMS sum total harmonic distortion of 0.05% of the fun-
damental output voltage.
2£0.1dB 20Hz-20KHz at 1 watt into.8.ohms;
+1,2dB 5Hz-LOOKHz at 1. watt. into' 8.ohms.
40 watts RMS into 8.ohms, per channel, both channels operating, 0.1% total harmonic
distortion. :
Less than 0.001% from 20Hz-400Hz, and increasing linearly to 0.05% at 20KHz at 35
watts RMS per channel into 8 ohms.
Less than 0.05% from 0.01 watts to:0.25 watts, and less than 0.01% from 0.25 watts to
35 watts into 8 ohms per channel.
6 volts per microsecond (slewing rate is the maximum value of the first derivative of the
output signal, or the maximum slope of the output signal).
Greater than 400, DC-400Hz into 8 ohms.
Less than 15 milliohms in series with less than 3 microhenries.
Rated for 8 ohm usage; safely drives any load including completely reactive loads.
20.642% or 26.340.2dB at maximum gain.
0.75 volts +2% for 28 watts into 8 ohms.
Unbalanced, dual channel.
|
' :
:
j
i
i
:
| i
i
|