Summary of Contents for Facile ST11-850
- Page 1 Instruction manual ELECTRIC MIXER Instruction Manual ST11-850 Warning: To reduce the risk of injury, user must read instruction manual.
- Page 2 Instruction manual The following pictograms may be used in these operating instructions / on the device: WARNING—To reduce the risk of Do not work with material containing injury, user must read instruction manual asbestos, wear a dust mask Wear eye protection Wear hearing protection Dispose packaging and appliance in an Class II appliance...
- Page 3 Instruction manual Features Auxiliary handle Motor Speed control wheel ON / OFF switch Paddle Technical data Nom. Voltage: 230V ~ 50 Hz Rated Power: 850 W No-load Max speed: 180-700/min Spindle size Whisk ø 120 mm Protection class: II / Wear ear protection! Main handle Max.
- Page 4 Instruction manual that the vibration emission during actual use of the power tool can differ from the declared total value depending on the ways in which the tool is used; avoid vibration risk suggestion: 1) wear glove during operation 2) limit operating time and shorten trigger time General Power Tool Safety Warnings WARNING Read all safety warnings and all instructions.
-
Page 5: Caution Utility Services
Instruction manual c) Prevent unintentional starting. Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. -
Page 6: First Use
Instruction manual Use only the accessories and attachments detailed in the operating instructions. The use of inserted tools or accessories other than those recommended in the operating instructions could lead to you suffering an injury. Before first use WARNING! DANGER OF INJURY! Switch the device off and pull the plug out of the mains socket before carrying out any work in the device. -
Page 7: Carbon Brush Replacement
Instruction manual Carbon brush replacement The carbon brush must be checked and maintenance when the machine operation up to 60hours, please change the brush in time if find the brush worn out. Loosen carbon brush cap first, Pull out and replace the carbon brush (Always replace the two brushes at the same time), screw carbon brush caps. -
Page 8: Service Centre
Instruction manual any flammable materials in the machine;The vent must be often cleaned; Store the device & accessories in a dry room where out of the reach of children also. Only original parts can used in this machine. Service centre WARNING! Have your device repaired only by qualified specialist personnel using original manufacturer parts only. - Page 9 Instruction manual ELECTRIC MIXER BOM...
- Page 10 Instruction manual Name Name 1 Bearing cover 25 Brush holder 2 Locating pin 26 Carbon brush 5X8X14 3 Spindle 27 Brush cover 4 Parallel key 28 Rear cover 5 Bearing 6003 2RS 29 Screw ST4X14 6 Bearing 607 30 Handle 7 Second-level gear shaft 31 Screw ST4X18 8 Steel Ball3...
Need help?
Do you have a question about the ST11-850 and is the answer not in the manual?
Questions and answers